The following instructions are provided to assist you in configuring the Wave6 System in an overhead ‘cloud configuration’. This
configuration allows the Wave6 to be hung above a mix or any other critical listening position.
If the Wave6 System is to be mounted to the sidewalls, Auralex Mounting Blocks (included in WaveLens packaging) should be used.
Additional items you may need for this install (not included): level, pencil, drill, ladder, drywall screws, cable, chain, aircraft wire, nylon line etc.
Hanging Hardware Wall Mount Hardware
(2) Hex Wrenches (12) Connector Bolts (12) Connector Nuts (4) Cable Assemblies
(8) Mounting
Screws
(8) Wall Anchors
(24) Mounting
Blocks
➊
CHOOSE LAYOUT: Arrange WaveLens on floor to achieve desired pattern. See below for layout ideas. Ensure the side to be viewed
from below is face down on floor.
MARK & DRILL HOLES: Drill using
1
/4” drill bit
Side-By-Side Mounting: Each attached WaveLens should
contain a minimum of 2 connector bolt pairs. Mark the
drill hole position from each end of the WaveLens
using the template on the following page.
➋
Sustain
™
Wave6
™
1258-1210 | Rev. 1 | 122110 TME
Wave6
™
Installation Guidelines for Cloud Configuration
Staggered-Mounting: For staggered connections, mark WaveLens
(A) with the template. Drill holes. Position along side
WaveLens (B) according to desired pattern. Mark drill
hole position for WaveLens (B) through existing drill
hole on WaveLens (A).
A
B
B
www.Auralex.com
|
1-800-959-3343
|
|
Total Sound Control
®
Kommentare zu diesen Handbüchern